Morcem® Cal Acabado CR CSI W2

Composition

Product made with NHL 3.5 lime, selected aggregates and other additives.

Features and applications

• Highly permeable interior and exterior coating.
• Highly compatible with traditional systems and so suitable for renovation use.
• Application on newly built interiors and exteriors for enhanced habitability conditions compared with cement-based mortars.
• Permeable to water vapour, allowing the substrate to breathe.
• Excellent adherence.
• Great plasticity.
• Smooth or sponge floated finish.
• Contains no cement.
• Apply by hand or with a pump.
• Plaster and stucco works.

Substrates

• On surfaces substrates previously treated with MORCEMCAL BASE.
• The surface should be moistened thoroughly, waiting for the film of water to disappear before applying. 
• Do not apply on clay or on paint.

Instructions for use

MECHANICAL APPLICATION:

• Fix the optimum proportion water/mortar according to the chosen pump (section and hose length) and external weather conditions. Start with 18% proportion and modify it gradually until you achieve the appropriate consistency.
• It is important to maintain the same variables affecting the features of the applied mortar (distance to the wall, angle of application and water proportion).

MANUAL APPLICATION:

• Add water and mix mechanically until it takes on an even and workable consistency.
• Spread the mixed product over the substrate with the use of a trowel.
• Spread to a thickness of no more than 0.8 cm.

To assure ensure good compatibility between the surface substrate and the coatings, take the following steps:

• Wet the surfaces thoroughly at least 24 hours before applying, 
• Cure the material applied for 24 hours after applying. 
• Before finishing coatings with MORCEMCAL ACABADO, wait 24–48 hours per centimetre of mortar base coat.